FT Panel Clips for Voron V0/V0.1/V0.2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the full set of FT Panel clips for the Voron V0.2 which is built using 1515 extrusions.
- Ocena
- 5 / 5
- Polubienia
- 52
- Pobrania
- 155
- Wydruki
- 1
- Wyświetlenia
- 1429
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
FT PANEL CLIPS for Voron V0/V0.1/V0.2
As requested, the FT Panel Clips have been shrank down to work with 1515 extrusions. This Printables post is specifically Voron V0/V0.1/V0.2 printers.
INTRODUCTION
FT Panel Clips are designed to replace the panel clips that typically use M3 hex nuts + screws in the Voron V0, Micron and similar printers that use 1515 extrusions.
These panel clips were designed to make servicing the printer easier with the quick release design. All parts to mount the panels are printed and serve as a direct replacement for the original panel mounts freeing up all of those M3 nuts and M3x8 BHCS screws.
IMPORTANT NOTE: - If the clips are too lose. Check your printer calibration as it is likely that the Brackets have too much squish which would affect the actual height the keys are to lock in place.
INSTALLATION INSTRUCTIONS
These are the easiest Panel clips to date as they do not require 1mm or 3mm foam tape to be used (not supplied in the Voron V0 kits). These panel clips are designed to replace the original parts without the nut and screws.
For NEW printer builds
- Do not insert the M3 nuts where needed for mounting panels.
- Use the corner Corner Panel Bracket + 2 x keys for each corner of a panel
- Use the Panel Bracket + key in between Corner Brackets as needed.
- For door assembly use the hinge and clips in the Door folder.
For existing printers
- Recommended to remove the M3 hex nuts used to hold the original panel clips to avoid rattling while using the printer.
- Use the corner Corner Panel Bracket + 2 x keys for each corner of a panel
- Use the Panel Bracket + key in between Corner Brackets as needed.
Should you have any queries reach out to us on Discord
Hope that you appreciate the amount of time and effort to turn around such a big modification. If you like my designs and would like to contribute to fund filaments and other equipment required for prototyping, please do so at my paypal.me or Ko-fi. Your support is greatly appreciated :)
Do let me know if there are any other combination thickness panels and foam tape that you want to use and additional STL's can be provided.