1 / 3
HGX Lite and HGX 2.0 Single Drive Gear Mod
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mod to convert the HGX extruders to single drive gear for better extrusion consistency.
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 69
- Wydruki
- 1
- Wyświetlenia
- 3761
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 1) (Komentarze: 6)Remiksy (0)Kolekcje (41)Powiązane
I wanted to improve the extrusion consistency of the HGX Lite and HGX 2.0 oblique tooth extruders by converting them to single drive gear.
For reference: https://www.youtube.com/watch?v=c6JmCdovE0U
Unfortunately i didn't have done comparable before and after prints, but the quality with single drive is better in opinion. Please share your experience in the comments.
BOM:
- 1x bearing 623ZZ, 3x10x4 mm, e.g. https://www.aliexpress.com/item/1005001707861454.html
- 1x aluminum Bushing/Gasket D18xd10.2, H4, https://www.aliexpress.com/item/1005006029400618.html
- 3D printed spacer in ABS or ASA for heat resistance
Instruction
- disassemble the extruder until you got the spring loaded lever freed
- push the pin that holds the extruder gear in the lever
- it might be hard to get the pin out. On one HGX 2 it was loose, on another HGX 2 i needed a drill press to force it out
- replace the gear with the aluminum bushing with the bearing inside and the printed spacer (sand the spacer on the rough side a little bit before that)
- assemble the extruder
- optional: fix the pin with a tiny drop of super glue on one end
The photos show the mod for an HGX 2.0.