1 / 3
HGX Lite and HGX 2.0 Single Drive Gear Mod
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A mod to convert the HGX extruders to single drive gear for better extrusion consistency.
- Rating
- 0 / 5
- Likes
- 24
- Downloads
- 69
- Makes
- 1
- Views
- 3,761
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Voron Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
I wanted to improve the extrusion consistency of the HGX Lite and HGX 2.0 oblique tooth extruders by converting them to single drive gear.
For reference: https://www.youtube.com/watch?v=c6JmCdovE0U
Unfortunately i didn't have done comparable before and after prints, but the quality with single drive is better in opinion. Please share your experience in the comments.
BOM:
- 1x bearing 623ZZ, 3x10x4 mm, e.g. https://www.aliexpress.com/item/1005001707861454.html
- 1x aluminum Bushing/Gasket D18xd10.2, H4, https://www.aliexpress.com/item/1005006029400618.html
- 3D printed spacer in ABS or ASA for heat resistance
Instruction
- disassemble the extruder until you got the spring loaded lever freed
- push the pin that holds the extruder gear in the lever
- it might be hard to get the pin out. On one HGX 2 it was loose, on another HGX 2 i needed a drill press to force it out
- replace the gear with the aluminum bushing with the bearing inside and the printed spacer (sand the spacer on the rough side a little bit before that)
- assemble the extruder
- optional: fix the pin with a tiny drop of super glue on one end
The photos show the mod for an HGX 2.0.