Nanoleaf Hex Modular Controller box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Small box to hang below your Nanoleaf Hex Modular light to house an ESP32, microphone, and input power.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 254
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I didn't like storing the ESP32 that runs WLED in one of the hex bodies because it can make wiring harder and cause shadows. So I designed this small box to hang below using the same screws.
The width of the box is just right for an ESP32, https://amzn.to/3xMPXs4 and a right angle USB cable.
There is a pocket to press fit in a INMP441 microphone, https://amzn.to/3WazCGT . It works pretty well but does induce a bit of directionality to the mic.
For power I use this USB-C PD breakout with all the solder bridges removed so that it outputs 5V. https://amzn.to/4cvf3L1. The cable slot in the bottom of the box grabs onto an Anker USB-C cable well and I use this one so that it is long enough, https://amzn.to/3RVfgiu.
I also use an Anker USBC power supply that can provide up to 3A at 5V, https://amzn.to/3XLKo7U. I am running 144LEDs and it draws at most 2.2A when fed from both sides of the strips.