Nanoleaf Hex Modular Controller box
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Small box to hang below your Nanoleaf Hex Modular light to house an ESP32, microphone, and input power.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 16
- Makes
- 0
- Views
- 254
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Wall-mounted
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I didn't like storing the ESP32 that runs WLED in one of the hex bodies because it can make wiring harder and cause shadows. So I designed this small box to hang below using the same screws.
The width of the box is just right for an ESP32, https://amzn.to/3xMPXs4 and a right angle USB cable.
There is a pocket to press fit in a INMP441 microphone, https://amzn.to/3WazCGT . It works pretty well but does induce a bit of directionality to the mic.
For power I use this USB-C PD breakout with all the solder bridges removed so that it outputs 5V. https://amzn.to/4cvf3L1. The cable slot in the bottom of the box grabs onto an Anker USB-C cable well and I use this one so that it is long enough, https://amzn.to/3RVfgiu.
I also use an Anker USBC power supply that can provide up to 3A at 5V, https://amzn.to/3XLKo7U. I am running 144LEDs and it draws at most 2.2A when fed from both sides of the strips.