1 / 1
mAx Team 3mm LED Light Ramp, Antennas and Sunroof Upgrade for 3D SETS Model 14 (Max Team) — zdjęcie 1

mAx Team 3mm LED Light Ramp, Antennas and Sunroof Upgrade for 3D SETS Model 14 (Max Team)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Transform your 3D SETS Model 14 Max Team as the mAx Team van with a 1 color 3D printer

Ocena
5 / 5
Polubienia
16
Pobrania
128
Wydruki
2
Wyświetlenia
586
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Warning

This upgrade was designated 18 months ago and assembled over 16 months ago. I had never shared it because it is tricky and the result of printing a part is not perfect as expected, but once everything is assembled no default are visible.
I'm finally sharing it (and it will be the last upgrade for the mAx-Team) because it was asked to me this week.
Sorry, I'll let you see the sizes of the screws because I've since forgotten its a little.

Definition

No.

Printing

Is required the same printer size than 3D SETS has defined.

Use the same setting than 3D SETS.

For the small antenna, you need to print twice the left and right antenna parts

Build

Supports should be removed for the Roof1.

The build required extra screws to assemble the modified Roof1 and the Roof1 led blocker; I think it M2x6.

Like on 3D SETS build guide, don't forget to drill 2 2mm holes on the Roof1 to screw the sun blade.

Use glue to assembly the right  and left antenna parts

For the 1.75mm antenna use a piexe of 1.75mm filament and slide it into the antenna support

Feedback

It is welcome.

Remark

None.

Version

v1/v20240706 1st upload.

Tagi