1 / 2
StarTech 4 HDD Bay Hot Swap Fan Upgrade
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement fan housing to install a larger 80 x 25 mm fan.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 427
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
Lets you replace the 80 mm x 20 mm stock fan on with a common 80 mm x 25 mm size upgraded one on the StarTech HSB4SATSASBA “4 Bay Aluminum Trayless Hot Swap Mobile Rack Backplane”.
Bill of Materials
- 4x M3 x 30 mm screws
- 4x M3 x 5 mm x 5 mm threaded brass inserts
- 1x 80 mm x 25 mm fan
Tools Required
- Flush cutters (a.k.a. “side cutters”)
- Hobby knife
- 4.5 mm drill bit
- Pin vise, rotary tool, or drill
- Soldering iron, preferably with a threaded insert tip
Installation
- Remove the back panel, PCB, fan housing, and fan.
- Trim the narrow portion of the screw holes (that inserted in the stock fan) using cutters. Ensure the surface is nice and flat with the hobby knife.
- Widen the holes
- Insert the brass threads
- Reassemble using your printed part, upgraded fan and longer screws. Done!
Notes
- The missing bar on the grille has been fixed in the uploaded model.
- The model shown on the photo was printed in ABS; PETG should also be suitable, PLA might not be if the inside of your case gets particularly warm.
- The “external” model has a notch to connect your fan directly to a motherboard header or other external power source of your choosing; the “internal” is for those who connect their new fan to the backplane PCB.