1 / 3
inReach Mini 1 holder for Kriega backpacks
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Semi permanent holder for inReach Mini 1 for Kriega backpacks
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 513
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (16)Powiązane
I needed something sturdy to keep the inReach Mini 1 on myself while riding my motorbikes off-road. I have two Kriega trail backpacks, so I decided to print a holder that will be using zip-ties to attach inReach to my backpacks.
You will need:
- 2x 4.5 mm zip ties (carry more if you need to reattach it)
- 1x countersunk bolt M4x6mm (apply a little bit of Loctite 243)
For printing I have used PETG, 0.20 mm QUALITY, 30 % Infill, 3 perimeter shells, no supports.
Please note you may need to cut the notch to be square after printing. I did not test this with Mini 2, but it might fit.