Tactor Cup and Phone Tray
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cup holder and tray for Kubota L35 tractors
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 94
- Wydruki
- 0
- Wyświetlenia
- 828
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This is cup/mug holder and phone tray I designed to mount on my fathers tractor. Designed to mount onto the right fender of a Kubota L35 using pre-existing holes in the fender. Part is designed to use 5/16"-18 bolts. The model has also been cut into two halves to fit on smaller print beds. The two haves can be glued together with CA or epoxy. I have also included a full size part without mounting features for other uses.
I printed the part in PETG at 20% infill using a Prusa i3. The 2 haves were glued together using CA (cyanoacrylate). I mounted the final assembly on the fender using 2x 5/16"-18 bolts with washers and locknuts. Be sure not to over-tighten and crush/warp the plastic.
Notes:
-Uses 2x 5/16"-18 Bolts
-Mounting hole spacing - 140mm on center
-Cup holder ID - 85mm
-Approx. Tray dims - 196mm long x 118mm wide
-I used a brim. Supports from ground surface only.
This is my model I also have uploaded to Thingiverse: https://www.thingiverse.com/thing:5021662.