1 / 3
Loop Earplugs Mute Holder Attachment
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An attachment that holds Loop Mute rubber inserts, compatible with Loop Earplugs case. Finally a way to carry them...
- Ocena
- 4,786 / 5
- Polubienia
- 63
- Pobrania
- 711
- Wydruki
- 17
- Wyświetlenia
- 3783
- Oceny
- 14
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 17) (Komentarze: 23)Remiksy (2)Kolekcje (91)Powiązane
About
An attachment that holds Loop Mute rubber inserts, compatible with original Loop Earplugs case.
I have always wanted a way of carrying the Mute rubber inserts to further reduce noise when needed, so I designed this attachment that fits in the lid of the Loops Earplugs case.
My Print Settings
- Material: PLA
- Infill: 20% (don't think it matters because it's so thin)
- Supports: Tree
- Orientation: flat surfaces of the cylinders facing the print bed
Installation
- Insert the bottom prong of the Y-shaped attachment into the two slots at the hinge of the Loop Earplugs case.
- Press the two upper prongs of the Y into the case. You should hear a small snap, indicating it has slotted under the case's lip.
- Note: The attachment should flex slightly, ensuring a snug fit due to tension and compression.
Removal
- Ensure the Loop Mutes are removed from the attachment.
- Slide out one of the upper prongs by pushing the top of the Y to the side until it releases.
- While holding the released prong, slide the other prong in the opposite direction until it releases.
Feel free to reach out if you have any questions.