Pickle Ball Paddle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Look no further, your 3D printed pickle ball paddle is here. 2 Piece design, fits a 254x254x254 build volume.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 230
- Wydruki
- 0
- Wyświetlenia
- 923
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
- 3 walls
- 20% infill
- print @ 45 deg angle
- tree supports at edges (refer to picture)
- 0.2 layer height
- 0.4mm nozzle
- printer/setting dependent
- K1 Max
- PLA ~ 6.5 hrs
- ABS ~ 8.5 hrs
- K1 Max
- https://www.printables.com/model/600513-orca-slicer-profiles-for-k1-k1c-k1-max-04-and-06-u
- ABS Orca Slicer K1Max Settings Thx @RetroD
Printed in PLA or ABS. Both work well. Good sound at 20% infill. Don't know the sound change with different infill % or if you print it at different angles. Printing at 45deg and 45% gives it a rigid feel.
Fits a 254x254x254 build volume. I printed it on a K1Max
3 walls and 20% infill gives it a good sweet spot, and weight, but I'm going to play with different infill and different infill percentages closer to edges to maximize the sweet spot.
Note, print edges with tree support
Glue together, can make a dowel pin if needed
Racquet Tape to finish it off!
If there is demand, ill happily upload an un-branded version that is remixable.
Cheers!