1 / 9
Ender 3 v3 SE dual 5015 fan ducts — zdjęcie 1
1 / 9

Ender 3 v3 SE dual 5015 fan ducts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dual 5015 fan duct created to eliminate cheap fan rattling problem

Ocena
5 / 5
Polubienia
81
Pobrania
341
Wydruki
1
Wyświetlenia
3134
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Let me introduce my own project, it was created to eliminate cheap 5015 fan rattling problem mounted perpendicular when X-axis move. To solve that I place both fans parallel to X-axis, also move it ale the way up that they can take cold air.

Fans are parallel connected, You will need JST 1,25 2-pin female connector (with cables are easier to use) to connect it to print head board.

To fasten fans at the moment I use two 3,8mm zip ties, but You can also use m4 bolts and nuts if You want (only upper mount will holds it just fine).

Printing:

I use PETG Fiberlogy Matte black filament, as You can see models are created to lay down when printing, so it's very simple to print. Supports are needed in only few places.

Tagi