JBL Boombox 2 charger holder/stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
JBL Boombox 2 holder/stand for the 220v AC charger!
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 583
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hi guys!
I'm new to 3d modeling for 3d printing and I'm trying to dive into, so this is my first design ever!
Not the greatest one but still very useful and practical because the charger of this speaker have pretty long cables that require a bit of messy room around when have to store them :)
Did all the measurements myself on my JBL Boombox 2 and create it all by myself in Fusion 360!.
After few test prints the end result is satisfying, it grips very very strong to the handle of the speaker, you can literally hang it on the wall with this.
It's job is to hold the charger onto the speaker while charging, or to hold it with all the cables around it as a stand, it stays straight!
Perform a twist move around the handle from the back/front side.
Please use both hands when placing on and taking off to prevent possible cracks! :)
I did it quite a lot of times already, no issues!
Printed straight up as it stands with tree supports, bottoms are a bit bad looking, but you don't see them often ;)
Test prints were with PLA with low infill but the main print is in:
Qidi Odorless ABS
5 walls, 5 tops, 5 bottoms, 20% infill