1 / 2
4040 extrusion Relay Holder | Ender 3 V2 under Y-axis — zdjęcie 1
1 / 2

4040 extrusion Relay Holder | Ender 3 V2 under Y-axis

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A neat little part that allows you to mount a relay to the 4040 extrusion perpendicular to the Y-axis on the Ender 3 V2.

Ocena
0 / 5
Polubienia
1
Pobrania
11
Wydruki
0
Wyświetlenia
104
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This part allows you to mount a small generic relay to any 4040 extrusion, but has been specifically designed to fit under the bed axis extrusion on an Ender 3 V2 (see pictures).

 

Material:

PLA will probably hold up fine on an unenclosed printer, if your printer is enclosed I'd recommend using a more temperature resistant filament like PETG or ABS

BOM:

Mounting to the extrusion:

  • 2x M5 twist in T-nut
  • 2x M5x8 bolt

Mounting the board to the part:

  • 3x M3x6 bolt

 

To mount the part, push the M5x8 bolts through the large holes in the part, and slightly screw them into the twist nut. Put the part in place and thighten the bolts. You can now mount the relay to the part using the M3x6 bolts that screw directly into the plastic.

 

It's a highly specific model, but I figured I'd publish it as it might save someone a bit of time :)

Tagi