1 / 1
Playmobil PM-18 9404 sportive car roof
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
2 roof versions for the Playmobil PM-18 9404 car
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 594
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Attribution — Noncommercial
My son demanded one of his Playmobil cars to have a roof as otherwise it may get wet when it's rainy.
This has proven to be a little challanging as the roof has curvatures in 2 directions and there is no step on the lower edge of the remaining structure for it to not fall into the car.
This was solved by
- printing it on the side (requires supports for the fillets of the corners, also a support structure had to be integrated to stabilize the print so it won't tip over when printing)
- adding a “roof scoop” at the front and a spoiler at the back to keep the roof from falling into the car
Available prints
- regular one (displayed in the foto)
- more sportive one, with big roof scoop and big spoiler
Printing instructions
- 0.1 layers to get a smooth texture
- no infill at all required
- add support blocker for the roof scoop (front)
(works nicely even without supports, it's small enough) - add supports from build plate
Post processing
Clip off the support structure with a side cutter.