1 / 2
4mm Banana plug to breadboard adapter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
fits for Breadboards with 42.5mm between the two inner power rails
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 629
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 2)Remiksy (0)Kolekcje (32)Powiązane
Fits breadboards with 42.5mm between the inner two power rails. Mine are Elegoo-branded ones from Amazon. Given the dimensions of the perfboard, it should definitly also fit breadbords with up to 43.2mm between the rails (however, I have not tested that).
As the power rails on my breadboard are not an even inch-spacing apart, the best way to proceed is to push the pin-headers into the breadboard and then push the board ontop of them, leading to a slight tilt in the headers before soldering them to the board.
You'll also need:
- ½ 60x40mm perfboard with mounting holes 54.5mm apart (you can find them in many sets on e.g. amazon).
You can scratch the board with a knife and ruler and break it apart in the middle. Then you can cut out the middle part using a jigsaw (see attached photo). The necessary soldering is pretty self-explainatory. - 2 5x2 pin headers
- 4 4mm banana plugs (I've used these ones https://www.amazon.de/-/en/dp/B0BNXDZWDN, with different ones you might need to change the hole sizes)
- (optional) 2x2 pin header + jumpers to connect the rails
- some wires to connect the plugs to the board and pin-headers
- 2 short M2 screws & nuts