1 / 2
4mm Banana plug to breadboard adapter
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
fits for Breadboards with 42.5mm between the two inner power rails
- Rating
- 0 / 5
- Likes
- 21
- Downloads
- 38
- Makes
- 0
- Views
- 629
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Share Alike
Fits breadboards with 42.5mm between the inner two power rails. Mine are Elegoo-branded ones from Amazon. Given the dimensions of the perfboard, it should definitly also fit breadbords with up to 43.2mm between the rails (however, I have not tested that).
As the power rails on my breadboard are not an even inch-spacing apart, the best way to proceed is to push the pin-headers into the breadboard and then push the board ontop of them, leading to a slight tilt in the headers before soldering them to the board.
You'll also need:
- ½ 60x40mm perfboard with mounting holes 54.5mm apart (you can find them in many sets on e.g. amazon).
You can scratch the board with a knife and ruler and break it apart in the middle. Then you can cut out the middle part using a jigsaw (see attached photo). The necessary soldering is pretty self-explainatory. - 2 5x2 pin headers
- 4 4mm banana plugs (I've used these ones https://www.amazon.de/-/en/dp/B0BNXDZWDN, with different ones you might need to change the hole sizes)
- (optional) 2x2 pin header + jumpers to connect the rails
- some wires to connect the plugs to the board and pin-headers
- 2 short M2 screws & nuts