Infimech 270 door hinge

Update 7/14/24

Updated the door latch

• now door has no wobble during print.
• now door latch can snap on the screw, so no need remove whole side panel.

___________________________

Update 7/15/24

Minor improve on the hinge insert nut placement

• looser tolerance,and only 1 pause needed now

___________________________

Update 7/27/24

Noticed some material might have hard time print on the nut, updated ceiling path as bridging to avoid problems. 

Older version gonna be replaced/cleaned.

____________________________

Update 8/24/24

Updated the door latch

• reinforced the structure based on feed back
• loosen the tolerance, and changed the opening for easier install, and uninstall  

for installing the door latch:

•  slowly unscrew the screw out about 1-2mm, while applying a pulling outward force.
• snap on the latch, and then tighten the screw