Plaster Cast Pot for 100mm inner Pot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mold (negative) for a plaster pot.
- Ocena
- 0 / 5
- Polubienia
- 51
- Pobrania
- 191
- Wydruki
- 0
- Wyświetlenia
- 1270
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
A mold (negative) for a plaster pot.
You need to print five of the sideparts and one each of the inner and the top part.
Atleast the big inner part needs a good sanding and maybe mold seperator, i used normal olive oil and it worked just fine; else it will be really hard to seperate the part from the pot.
Prints without supports, needs just little infill but probably 3-5 shells.
Uses 3 big (or more smaller) cable ties, like shown in the pictures attached.
If you use a water absorbing material like i did (plaster) you should use a inner pot (or a coating), so the plaster doesn't get wet. I used a Geli 10cm pot with a matching coaster which fit perfectly. https://www.idealo.de/preisvergleich/OffersOfProduct/6010766_-blumentopf-10cm-weiss-geli-thermo-plastics.html
Pictures with a plant inside will follow.