Plaster Cast Pot for 100mm inner Pot
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A mold (negative) for a plaster pot.
- Rating
- 0 / 5
- Likes
- 51
- Downloads
- 191
- Makes
- 0
- Views
- 1,271
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
A mold (negative) for a plaster pot.
You need to print five of the sideparts and one each of the inner and the top part.
Atleast the big inner part needs a good sanding and maybe mold seperator, i used normal olive oil and it worked just fine; else it will be really hard to seperate the part from the pot.
Prints without supports, needs just little infill but probably 3-5 shells.
Uses 3 big (or more smaller) cable ties, like shown in the pictures attached.
If you use a water absorbing material like i did (plaster) you should use a inner pot (or a coating), so the plaster doesn't get wet. I used a Geli 10cm pot with a matching coaster which fit perfectly. https://www.idealo.de/preisvergleich/OffersOfProduct/6010766_-blumentopf-10cm-weiss-geli-thermo-plastics.html
Pictures with a plant inside will follow.