Sovol SV08 Bambulab Hotend Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the design made by Stephi witch is great. I have just added heat set inserts because i didn't have square nuts
- Ocena
- 3,75 / 5
- Polubienia
- 79
- Pobrania
- 428
- Wydruki
- 4
- Wyświetlenia
- 4651
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to print my top hat in Carbon Fiber PETG so i needed a solution to be able to print PETG without being afraid to lose my nozzle and damage the printer and a hard nozzle to can print Carbon Fiber reinforced PETG
This is the design made by Stephi Dupont witch is great. i have just added heat set inserts because i didn't have square nuts.
I have used the thermistor and the heater that came with the bambu hot-end thanks to Adrian@3DPrintMasters that was kind enough to send the hot-end for testing
I had to increase the length of the thermistor and the heater wire.
The thermistor uses 2 pin JST 1.25 connector and the heater uses 2 pin JST PH2.0 connector
I didn't need to modify the Z offset but it your case might vary so make a Z offset calibration after this mod.
Stephi said that you will need 27mm ptfe tube but i had to cat it shorter. didn't measure it after. but it was less than 12mm you need to see. i have used capricorn tube 1.9mm ID and 4mm OD