Sovol SV08 Bambulab Hotend Support
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is the design made by Stephi witch is great. I have just added heat set inserts because i didn't have square nuts
- Rating
- 3.75 / 5
- Likes
- 79
- Downloads
- 427
- Makes
- 4
- Views
- 4,636
- Reviews
- 4
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to print my top hat in Carbon Fiber PETG so i needed a solution to be able to print PETG without being afraid to lose my nozzle and damage the printer and a hard nozzle to can print Carbon Fiber reinforced PETG
This is the design made by Stephi Dupont witch is great. i have just added heat set inserts because i didn't have square nuts.
I have used the thermistor and the heater that came with the bambu hot-end thanks to Adrian@3DPrintMasters that was kind enough to send the hot-end for testing
I had to increase the length of the thermistor and the heater wire.
The thermistor uses 2 pin JST 1.25 connector and the heater uses 2 pin JST PH2.0 connector
I didn't need to modify the Z offset but it your case might vary so make a Z offset calibration after this mod.
Stephi said that you will need 27mm ptfe tube but i had to cat it shorter. didn't measure it after. but it was less than 12mm you need to see. i have used capricorn tube 1.9mm ID and 4mm OD