1 / 3
Apple MagSafe charger holder with bonus cupholder for Toyota Corolla XII — zdjęcie 1
1 / 3

Apple MagSafe charger holder with bonus cupholder for Toyota Corolla XII

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Toyota Corolla XII Touring Sports

Ocena
5 / 5
Polubienia
17
Pobrania
84
Wydruki
0
Wyświetlenia
3076
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Standard Digital File License

Low space for storage near the driver seat, hard to reach and poor quality Qi charger (especially when phone has a lens that protrudes highly) and no refrigerated storage compartment available inside vehicle gave me an idea for design. 


I present you my idea for Apple MagSafe charger holder. You can glue your MagSafe charger to it and have a special place for your iPhone (fitted for iPhone 15 Pro and smaller, not sure if bigger ones will fit). Holder can be screw down or glue (or both as i did) to plastic triangle part of dashboard visible on photos. I choosed it because this part is easy to remove, very cheap and quite available online. 
It is also a storage for car key or cupholder in which you can (quite effectively) cool down any beverage during long summer drives using A/C vent.


Steps to install:

  • with special plastic tool for trim removal take out left side dash panel (the one close to driver doors)
  • gently pull out switch panel (do not need to remove it completely. Just enough to have full acces to triangle plastic dash panel)
  • pull out the triangle plastic part of the dash.
  • use previously printed charger cord cut template to draw a hole on plastic trim
  • cut/drill hole
  • drag charger cord through hole in holder and then through cut in triangle dash panel
  • glue or screw holder (i drilled 2mm whole before and used 12mm screws) to the panel as shown on the photo attached
  • before reinstalling dash triangle panel with holder attached you need to drag the cord to the inside of the dash. There is ideal place to do it
  • reinstall button panel and side panel
  • connect MagSafe charger to the cigarette lighter throughout compatible USB-C charger with support for power delivery (probably extension USB-C cord will be needed)

Note: This instruction is only sugestion how to do it. Note that you can use fuse piggyback interface instead cigarette lighter port. Everything is quite easy to perform but some technical skills and special tools are reguired. Remember that you are doing it on your own responsibility.

I'm open to any suggestions.
 

Tagi