Fysetc PITB V2 Din rail Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
mount the V2.0 Fysetc PITB on your din rail, using the Voron PCB din Bracket.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 311
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I want to mount my PITB in my electronics bay of my v2, because it was cheaper than two tmc5160's, and I dont see why its a good idea to put it in the hot enclosure, when my wiring already goes down to my electronics bay.
Thus, I made this little bracket to attach from the Voron 2.4 pcb din bracket, to the PITB V2.0 board from Fysetc.
NOTE: the v1 board appears to have been a different width, the hole spacing is about 170-170.1mm on the new board.
https://github.com/VoronDesign/Voron-2/blob/Voron2.4/STLs/Electronics_Bay/pcb_din_clip_x3.stl ←- pcb din clip link if you're lazy like me :)
Use two heat set inserts and the included plastic screws to attach the board, after using some m2's to attach the bracket to the din clip.
If you have problems getting your TMC 5160's to initialize and work with this board, look at my PR here to get it working with hardware spi: https://github.com/Klipper3d/klipper/pull/6683