CR-X upgrades stabilising rods charger stabiliser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Large format bed slingers suffer from instability and Z wobbling especially at high heights. There are models online of
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 147
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Large format bed slingers suffer from instability and Z wobbling especially at high heights. There are models online of stabilising rods for the CR-X's cousin (CR-10) but there are none for the CR-X - until now! These rods (and triangle braces) also provide a huge amount more stability at lower ranges, allowing for speedier printing.
Additionally, is a plug stabilising as my female plug on the CR-X was wobbly and would often result in a power cut upon the slightest bump.
Hardware required
- 770mm 10mm rods x2
- Nuts for 10mm rods x8
- 3mm screws x4 (about 10mm longer than the stock ones, for the bottom, the stock are not quite long enough)
- 4mm screws x2 (about 10mm longer than the stock ones, for the triangle brace for the sliding Z - axis)
- 5mm screws x4 (about 20mm longer than the stock ones, for the top rod holder)
Hope this helps someone out there.