CR-X upgrades stabilising rods charger stabiliser
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Large format bed slingers suffer from instability and Z wobbling especially at high heights. There are models online of
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 15
- Makes
- 0
- Views
- 147
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Creality Parts & Upgrades
- License
- Creative Commons — Attribution
Large format bed slingers suffer from instability and Z wobbling especially at high heights. There are models online of stabilising rods for the CR-X's cousin (CR-10) but there are none for the CR-X - until now! These rods (and triangle braces) also provide a huge amount more stability at lower ranges, allowing for speedier printing.
Additionally, is a plug stabilising as my female plug on the CR-X was wobbly and would often result in a power cut upon the slightest bump.
Hardware required
- 770mm 10mm rods x2
- Nuts for 10mm rods x8
- 3mm screws x4 (about 10mm longer than the stock ones, for the bottom, the stock are not quite long enough)
- 4mm screws x2 (about 10mm longer than the stock ones, for the triangle brace for the sliding Z - axis)
- 5mm screws x4 (about 20mm longer than the stock ones, for the top rod holder)
Hope this helps someone out there.