1 / 1
PTC heater fan holder with IKEA Tisken adapter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holder for a PTC heater with 60mm fan to hold it in place for my terrarium with an IKEA TISKEN suction base adapter.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 179
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Print three part separately and glue them together.
I used PLA, my heater is only set to around 30C and it is attached to the intake side so should not be a problem. The printed model on the photo has a higher extruded grid, but that made it difficult to attach to the base.
Other parts:
- IKEA TISKEN hook (I have the earlier model, the adapter is the same)
- PTC heater
This is my first model created with onshape and my first uploaded model, any feedback is welcome! :)
