Thermacell Refill Adapter (Durable)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For modified butane canisters (remove the one-way valve). Uses a piece of filament as valve pin for extra durability.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 176
- Wydruki
- 3
- Wyświetlenia
- 868
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Most Thermacell adapters are fragile because of the middle pin being so very thin. This version solves this problem by using a small piece of filament inserted into the middle hole. Fasten with e.g. CA glue.
The tolerances are very important for a good seal around the butane canister. The diameter of the hole should be just above 6,20 mm for easy insertion but also a tight seal. The model prints well with my current 0.4mm nozzle, but I have successfully printed it with a 0.6mm nozzle too.
The filament cut guide included is for cutting the filament to the proper length.
UPDATE V2: Smaller diameter hole for the gas tube, should not leak like the old version did when I recently printed it.