1 / 15
Gmade R1 Portal 7 & 13 Degrees C-Hubs — zdjęcie 1
1 / 15

Gmade R1 Portal 7 & 13 Degrees C-Hubs

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a printable version of the alum.

Ocena
0 / 5
Polubienia
6
Pobrania
35
Wydruki
0
Wyświetlenia
519
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

This is a printable version of the alum. 7-degree C-Hub that Gmade sells as an upgrade
I have made a 13 degrees version too now, since 7 is not alot..

V2 Files are now corrected and should be fine to print.
Tolerances around the outer edge are corrected (Was a problem in previous version).
If you print it in Nylon, PETG, ABS, it should be plenty strong.

Your choice of 7 or 13 degrees :

  • Complete Left and Right
  • Split Top/Bottom Left and Right (No supports)
    • (Glue the parts together after the print)
  • Or the newer and better WrHubs !
    UPDATE 2019 : I found the "Wrapters" which allow the use Axial AR60 cHubs/knuckles/universals for more steering throw. After 4 of them broke in not even a day (weak where you screw the cHubs into the adapter) i decided to remove that weak part entirely, effectively making a "WrHub". Cut the shafts to the same length, use the same tube for shimming as in the Wrapters instructions. 1 Additional 5x8x2.5 bearing needed per side (2 total) (same as those already in the portal box).

Print instructions

Category: R/C Vehicles

Tagi