Lab Mounting Plate for 38x38mm Camera Modules and Extension PCBs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mounting plate (test assembly) for 38x38mm IP camera modules and extension boards (ex. OpenIPC) with cable routing.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 260
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is the mounting plate described in our blog post:
https://subreption.com/blog/fpv-ipc-reverse-engineering/
This is not a drone related design and cannot be used for any other purpose except providing lab test assembly support, like any other similar mounting plates for PCB designs.
It can support either two 38x38mm camera modules with standard hole spacing, or one camera module and any extension board with matching pitch for the mount holes.
The plate provides the following features:
- Space for magnets at the bottom (to improve stability and adhesion to a metallic plate, like a Sensepeek PCBite kit).
- Strain relief for all cables.
- PG7 cable gland support for the main power and Ethernet cable ingress.
- SMA recessed bulkhead support (will fit any standard SMA bulkhead connector pigtail assembly).
- Four M4 binding posts.
M2 and M4 threaded inserts are used throughout.
It will be primarily useful for OpenIPC development, reverse engineering of camera modules and related engineering work for easy prototyping.
Print in ABS/ASA, preferably in a heated chamber. Adjust wall loops for strength.
No commercial use, distribution or derivative works permitted.