Wind guard for Samsung HMX-qf30
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a wind guard for the Samsung HMX-qf30 video camera.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 140
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a wind guard for the Samsung HMX-qf30 video camera. Just cut out a piece of kitchen sponge ca. 37mm x 12mm x 12mm (1,45in x 0,5in x 0,5in). it should stick out a bit to seal up nicely.
I've added a small flat surface on the bottom to keep it from toppling over.
Print Settings
Supports:
Yes
Resolution:
It looks fine in 0.2
Infill:
100%
Notes:
It is important that support is set to everywhere.
i printed in PLA and it's really strong.
Post-Printing
the support is easily removed after printing. then just cut out a 37mm x 12mm x 12mm (1,45in x 0,5in x 0,5in) piece of kitchen sponge, and place it in the cage. if the wind is still disturbing try with a larger piece of sponge to create a tight seal.
I don't know if the design fits other camcorders but if it has the same styled mic and the dimensions shown in the picture above, give it a try.