Wind guard for Samsung HMX-qf30
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a wind guard for the Samsung HMX-qf30 video camera.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 6
- Makes
- 0
- Views
- 141
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a wind guard for the Samsung HMX-qf30 video camera. Just cut out a piece of kitchen sponge ca. 37mm x 12mm x 12mm (1,45in x 0,5in x 0,5in). it should stick out a bit to seal up nicely.
I've added a small flat surface on the bottom to keep it from toppling over.
Print Settings
Supports:
Yes
Resolution:
It looks fine in 0.2
Infill:
100%
Notes:
It is important that support is set to everywhere.
i printed in PLA and it's really strong.
Post-Printing
the support is easily removed after printing. then just cut out a 37mm x 12mm x 12mm (1,45in x 0,5in x 0,5in) piece of kitchen sponge, and place it in the cage. if the wind is still disturbing try with a larger piece of sponge to create a tight seal.
I don't know if the design fits other camcorders but if it has the same styled mic and the dimensions shown in the picture above, give it a try.