Umikot V2 for SWORKS 49mm Step Down Basket

Remixed Umicot to fit the SWORKS 49mm Step Down Basket. 

Umikot will sit on top a standard 58mm Portafilter basket with gears and needle positions adjusted to WDT the inner 49mm area.  

-Required hardware and Print Properties are the same as the original Umikot by RedFoxDude. 
     https://www.printables.com/model/481587-umikot-58mm-version-planetary-gear-spirograph-espr
-Optional 5mm x 3mm magnets can be glued into the base. I find the magnets to be a nuisance but its there incase you like them.  
-Recommended Overall Needle Lengths (Including Handles)  
      75mm for Long Needles
      65mm for Short Needles
      I'd still recommend .35mm needles 

For now, I've included a 38mm deep cup stand for the Umikot. I found this to be the best one as you can fill it with rice and it'll clean your needles as you set it down and pick it up. 

Edit:

7/26/24 : Thank you to the one guy who downloaded the model, and many apologies.
      -Fixed Spin Ring to properly fit an M3 screw, Added Chamfer to said hole.
      -Adjusted Mechanism needle holes for better fitment. (No need to reprint the mechanism if your needles fit.)

8/9/24 : Updated Base moving magnet holes inward so that there is a little more material between the magnet and spiral pattern on the outside. Wall was too thin and some slicers wouldn't print it at all.