Sparsnäs Receiver Case (EspSparsnäsGateway)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for the Sparnäs Receiver/Gateway board that was designed by Anders Helin. The lid clicks in place by friction /…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 182
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Case for the Sparnäs Receiver/Gateway board that was designed by Anders Helin.
The lid clicks in place by friction / layer-lines binding.
I printed mine in PLA, with 0,6mm nozzle and 0,3mm layer height for fast print speed and it works well. (The lid stays on quite hard. A lower layer height might make it slide easier if someone wants it to be looser.)
Update:
Adde a lid with holes and mounting points for the external control board.
This one is not tested, as I don't have any ext-board.
Print Settings
Printer:
RigidBot Big
Rafts:
Doesn't Matter
Doesn't Matter
Category: DIY