1 / 4
DIY Sand Blast Booth - Glove Ports
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Flanges for glove ports for DIY Sand Blast Booth
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 51
- Wydruki
- 0
- Wyświetlenia
- 225
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (11)Powiązane
Built a DIY sand booth and designed the inlet flanges that hold the gloves for the hand ports.
Bottom Flange is inserted from inside the tote and the top flange from the outside. Flanges are then screwed together with (8) #6 - 1in screws and nuts.
Gloves were turned inside out at the ends and attached using zip ties once Top and Bottom pieces were screwed together.