1 / 5
Filament guide puley turn your printer chamber into budget drier
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Guide your filament anywhere from spool to extruder. Made with using printer chamber as a budget filament drier in mind.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
Only additional 2 parts required:
- 12x10 round neodymium magnet
- M3x12mm flat head philips or hex bolt
Use this to drive your filament anywhere from your spool to your extruder. I made this for the idea of using printer chamber with some moisture absorbers as a budget filament drier in mind as it easily heats close to 40°C thus extending filament travel path can theoretically dry it out. Use as many as you need.
- use PETG for more heat resistance and less friction
- 4 perimeters
- extra perimeters if needed
- 6/5 top/bottom solid layers
- 5% infill (I use gyroid)
- pause and insert magnet (I recommend using a screwdriver tip as it will remove some of that huge snap force to bed)
- insert puley and tighten in together
- use for example two sided adhesive tape to prevent driver from sliding and you're done