Redox(-W) Keyboard Tenting Case - 25 Degree Tilt
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case to put your Redox(-W) keyboard in to make it tilted by 25 Degrees. Needs to be modified for non-wireless variant!
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 366
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Share Alike
This is a case where you can just put in your Redox-W Keyboard in and have it tented by 25 Degrees. Tested with the Redox-W 2nd rendition with the official 3D-printed case. (https://github.com/mattdibi/redox-keyboard/tree/master/redox-w/rev2.0WHS/case)
Disclaimer:
I don't have the cable version of the Redox, so I didn't design a version to fit it. If you are interested I am happy to share my fusion- or step-file.
Print:
Print once normal and once mirrored for the other half of your keyboard.
I printed it face down to have a nice surface finish. Then it needs at least support for the part where the keyboard will lay on later. The inside bottom angle is 25 Degrees in that print orientation and can be printed without support if your printer can bridge such wide gaps. Doesn't look pretty, but you won't see it anyways, so I didn't care.
Printing it in the normal orientation won't use support and is preferred if some stepping on the top surface is fine for you.