Internal Overflow Strainer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I use a 1/2" PVC elbow on the inside of my overflow bulkheads.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 469
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
I use a 1/2" PVC elbow on the inside of my overflow bulkheads. My shrimp think it's a water slide and I usually find them in the sump later.
I started off with a cap style, but if it became clogged, I'd have a spill. So I came up with these, that still provide straining, but if the water gets high enough it will still drain unimpeded.
This style goes inside of a female 1/2" PVC fitting.
Updated 2019-03-29: Added a version where the gaps are smaller to attempt to get small fry from swimming through... (ugh)
Print instructions
Category: Hobby Print Settings
Rafts: No
Supports: No
Resolution: 0.2mm
Infill: 20%