1 / 4
Groove Life Belt Hanger w/Magnets — zdjęcie 1
1 / 4

Groove Life Belt Hanger w/Magnets

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Closet hanger for a Groove Life belt. Uses a custom mount and 8x2mm magnets to hold the belt firmly against the hanger.

Ocena
5 / 5
Polubienia
12
Pobrania
77
Wydruki
0
Wyświetlenia
334
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

There are basically 2 different configurations… 

#1   Using the ‘buckle’ attachment (Groove_Belt_Hanger2 v15) by itself to hang the belt full-length.

#2   Using both the ‘buckle’ (Groove_Belt_Hanger2 v15)  AND  ‘tail’ (Groove_Belt_Hanger_Part-2 v5) attachments together so the belt hangs half-length.

 

Hardware:

   8x2mm Neodymium/Rare Earth Magnets (3 for buckle hanger, 2 for tail hanger).

 

Suggested Print Settings:

   Perimeters:  4

   Fill Density:  20%

   Fill Pattern:  Rectilinear

   Filament:  PLA

   Rafts:  No

   Supports:  No

  Note: Be sure to place the tail end attachment face up on the bed when printing (see photo). I                 was able to get clean magnet holes (hanging side) without added supports.

 

IMPORTANT:  As sledutah stated, be sure you put the magnets in the holes in the correct orientation or else it won't work.

 

If you've received value from my work and wish to show some appreciation then please use the link below. Thanks

Buy me a coffee

Tagi