Groove Life Belt Hanger w/Magnets
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Closet hanger for a Groove Life belt. Uses a custom mount and 8x2mm magnets to hold the belt firmly against the hanger.
- Rating
- 5 / 5
- Likes
- 12
- Downloads
- 77
- Makes
- 0
- Views
- 334
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Public Domain
There are basically 2 different configurations…
#1 Using the ‘buckle’ attachment (Groove_Belt_Hanger2 v15) by itself to hang the belt full-length.
#2 Using both the ‘buckle’ (Groove_Belt_Hanger2 v15) AND ‘tail’ (Groove_Belt_Hanger_Part-2 v5) attachments together so the belt hangs half-length.
Hardware:
8x2mm Neodymium/Rare Earth Magnets (3 for buckle hanger, 2 for tail hanger).
Suggested Print Settings:
Perimeters: 4
Fill Density: 20%
Fill Pattern: Rectilinear
Filament: PLA
Rafts: No
Supports: No
Note: Be sure to place the tail end attachment face up on the bed when printing (see photo). I was able to get clean magnet holes (hanging side) without added supports.
IMPORTANT: As sledutah stated, be sure you put the magnets in the holes in the correct orientation or else it won't work.
If you've received value from my work and wish to show some appreciation then please use the link below. Thanks