Combustion Inc Thermometer Case (For small printers like A1 mini)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Combustion Inc Predictive Thermometer Case (A1 mini remix). Not compatible with "Range-Extending Booster".
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 255
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model is for a printer with small build volume like the A1 mini. If you have any other printer with a build volume larger than 184mm (for example 256mm3) use the original author's model instead.
This model does not support the Predictive Thermometer with Range-Extending Booster and only fits the Predictive Thermometer. Even if you do not have the booster version, if you have a larger build volume consider using the original author's model instead. Unless you are super sure you want the case to be smaller and you are not going to get the booster later.
I did not fully print this model because I have an X1 and I printed the original model. I also printed a cross section of this model to confirm the size alteration fit the standard predictive thermometer. I included a photo showing this.
The Prusa 3mf files are untested. I do not have a Prusa printer. I did my best to copy the settings from the original 3mf files.
Manual painted on supports are used on the lid to make removing supports easier.
I remixed the original to help out other users of small printers like the A1 mini that may be frustrated like I was that the original model is 184mm wide, 4mm larger than the A1 mini can accommodate.
This model like the original requires 6x M10 screws, 30mm long with a 0.5mm pitch. I used these from Amazon.
I used this Polyethylene padding on Amazon to fill my lid.