OpenBuilds Acro Reinforced Leg
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Drop-in heavily reinforced replacement for the stock legs on the OpenBuilds Acro.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 162
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
These legs have the same hole pattern as the stock legs, but with some improvements:
- They're now 7mm thick (minimum; the main wall is 12mm thick with the aluminum extrusion inset 5mm into it).
- They're 3-dimensional and have a reinforcing wall parallel to the Y axis, to reduce wobble along the Y axis.
- They have holes in the bottom for screwing directly into a table.
- They're slightly taller (127mm total height).
Each leg requires four M5x12mm screws (to attach to the aluminum extrusion) and two #8 wood screws (of a length appropriate for what you're screwing it into; I used 3/4in screws into a 1/2in sheet of plywood). Orient as shown in the picture and assemble in the same way as the stock legs. Two should be printed mirrored.
The X-axis extrusion is a tight fit into the slot; you may have to file down the plastic above/below it it if your printer doesn't print exactly on dimension.