OpenBuilds Acro Reinforced Leg
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Drop-in heavily reinforced replacement for the stock legs on the OpenBuilds Acro.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 25
- Makes
- 0
- Views
- 163
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
These legs have the same hole pattern as the stock legs, but with some improvements:
- They're now 7mm thick (minimum; the main wall is 12mm thick with the aluminum extrusion inset 5mm into it).
- They're 3-dimensional and have a reinforcing wall parallel to the Y axis, to reduce wobble along the Y axis.
- They have holes in the bottom for screwing directly into a table.
- They're slightly taller (127mm total height).
Each leg requires four M5x12mm screws (to attach to the aluminum extrusion) and two #8 wood screws (of a length appropriate for what you're screwing it into; I used 3/4in screws into a 1/2in sheet of plywood). Orient as shown in the picture and assemble in the same way as the stock legs. Two should be printed mirrored.
The X-axis extrusion is a tight fit into the slot; you may have to file down the plastic above/below it it if your printer doesn't print exactly on dimension.