Parametric Sectioned Cube
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My attempt to make the recently popular "sliding section fidget cube thingy" in a print-in-place, parametric version
- Ocena
- 4,862 / 5
- Polubienia
- 794
- Pobrania
- 5011
- Wydruki
- 40
- Wyświetlenia
- 16 254
- Oceny
- 29
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
I tried to make the “sliding section fidget cube thingy” that had a few versions pop up lately… but i wanted it to be parametric.
attached is a FUSION 360 file for you to mess around with and get custom sizes!
NOW IN KEYCHAIN SIZE!
(note the paramaters comments. to change parameters go to: MODIFY>CHANGE PARAMETERS>EXPRESSION)
The print i showed was done with PLA altho i would reccomend PETG since it slides better…
Make sure your bed adhesion and overhangs are on point! you could probobly get away with 0% cooling thanks to the looooooong layer time
--------------------------------------------------------------
P.S
if the sections move with too much friction, a solution i found it to WASH the print in water, while sliding the sections back and forth.
Congratulations to Gunny 3D for winning the 15*15 challange!
Honourable mention goes to Scott Yehle for his print!