Parametric Sectioned Cube
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My attempt to make the recently popular "sliding section fidget cube thingy" in a print-in-place, parametric version
- Rating
- 4.862 / 5
- Likes
- 794
- Downloads
- 5,011
- Makes
- 40
- Views
- 16,254
- Reviews
- 29
Updated at source:
Model information
- Source
- Printables
- Category
- Other Toys & Games
- License
- Creative Commons — Attribution — Noncommercial
I tried to make the “sliding section fidget cube thingy” that had a few versions pop up lately… but i wanted it to be parametric.
attached is a FUSION 360 file for you to mess around with and get custom sizes!
NOW IN KEYCHAIN SIZE!
(note the paramaters comments. to change parameters go to: MODIFY>CHANGE PARAMETERS>EXPRESSION)
The print i showed was done with PLA altho i would reccomend PETG since it slides better…
Make sure your bed adhesion and overhangs are on point! you could probobly get away with 0% cooling thanks to the looooooong layer time
--------------------------------------------------------------
P.S
if the sections move with too much friction, a solution i found it to WASH the print in water, while sliding the sections back and forth.
Congratulations to Gunny 3D for winning the 15*15 challange!
Honourable mention goes to Scott Yehle for his print!