Solder Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Screwable, reusable solder spool holder.
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 151
- Wydruki
- 4
- Wyświetlenia
- 809
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
Screwable, reusable solder spool holder. It should fit any less than 3cm wide spool with a hole bigger than 1.8cm. You can add small rubber stands to prevent slipping.
It has three parts. I would recommend printing it in two different prints. While printing the base, supports should be enabled to help print holes for screws. On the other hand, screws should be printed with higher infill to retain strong.
There might be problems with fitting the screws together. For me, it has a tight fit. You should be able to modify it with a little bit of sanding.
If you like this model, feel free to leave a comment. Contact me if you need help. Thanks :)