1 / 7
JWST Clock - 2.5in, fastned (Remix)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This remix of BadKitty's model uses 2.5in gold acrylic mirrors and a fastned 3D printed frame to make a JWST clock
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 127
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial
Similar to the original, the idea is to make a JWST shaped clock with reflective gold acrylic mirrors.
Prints:
- 1 X JWST_Clock_Center
- 9 X JWST_Hex_2.5in
Assembly notes:
- There is no need to put a screw in every hole, just use as many as you think is needed to hold it together
- I used 6x3mm screw for the clock center, and around 3x3mm screws to fasten every hex group to the others
- For the acrylic mirrors, I used hot glue to attach them to the hex frame
- At first, it did not stick very well to the smooth backing paper of the mirrors , so I tore off 3 corners per hex and put a drop of glue on each directly on each the exposed 2-sided tape that comes with the mirrors (see pictures).
Materials:
- 2.5" Hexagon Acrylic Mirrors: https://www.amazon.ca/dp/B08NCXVQYQ
- Clock mechanism (the one from the original model should work too): https://www.amazon.ca/dp/B08JLXLJJH
- 3mm screws (as many as you want to use)