Dual Remote Holder for TV / AV / Sound System remotes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom remote holder I designed for my TCL Google TV remote and Sony Sound System remote. Can easily be scaled.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 179
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution
There's not much space on the small table I keep next to my TV chair, so dealing with my 2 remotes is a bit cumbersome. I used cheap calipers to take the remotes' dimensions and then used OnShape to design a holder for them.
To print I used generic PLA, though I'm sure most others would work.
Note: print with high infill or use original model if you have thiccq remotes. The material saver can be quite light and easy to knock over if you use lower infills.
There are two versions:
- Original design features two equal slots for two remotes (57mm x 35mm each) and is 75mm tall. Pill-shaped cutouts save on time and space, and provide a nice visual touch.
- Material saver version is ⅓ shorter at 50mm tall, the cutouts are larger and side cutouts are added, to save on time and material. This is the one I've ended up using.
Recommended print settings:
- .2mm layer height (at most)
- 30% infill minimum, higher recommended for weight/stability.
- Adaptive layers with .1mm variation, .1mm topography size and .025 step variation
- Print near the bottom of your filament's recommended temperature range to minimize fuzzing/stringing
- If your remotes are quite heavy, the original design is recommended.