Rigol MSO1074 oscilloscope rack mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rack mount for the Rigol MSO1074Z oscilloscope - should fit other models from 1000Z series too (DS1xxx, MSO1xxx).
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 524
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Rack mount for the Rigol MSO1074Z oscilloscope - should fit other models from 1000Z series too like DS1xxx, MSO1xxx (check your model's dimensions).
Official rack mount kit is quite expensive (around 250€) so I made this one. It also contains a hole and an insert for additional stuff (I use mine for RedPitaya, logic probe cable, …) - at some point I might also design some drawers for the insert.
The model can be further optimized/skeletonized as it has A LOT of really unneeded plastic and I might do that if I'll be printing it again.
Due to the size (and the fact that I have PrusaMini with 180mm bed) I had to cut the model into three pieces.
Parts:
- rigol_rack_mount-Body.stl - main part
- rigol_rack_mount-glue_part 1&2 - for extra support when gluint together (two of each needed)
- rigol_rack_mount-bracket.stl, rigol_rack_mount-bracket_clamp.stl and rigol_rack_mount-bracket_clamp_mirror.stl - two of each needed
- rigol_rack_mount_insert-Body.stl - optional insert for storing extra stuff