Descendants remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a great model from Rockytfox, but I didn't fancy printing it as it was, so I used TinkerCAD and split the gold…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 59
- Wydruki
- 0
- Wyświetlenia
- 628
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Attribution
This is a great model from Rockytfox, but I didn't fancy printing it as it was, so I used TinkerCAD and split the gold tail in half but still printed with supports. I also put a hole in the bottom so I could put a tea light inside. I then used yellow cellophane over the D so it glows with the light rather than a bare LED shining through, or using a printed D which might be a little dim.
I also added the bite back in and printed it red to simplify the printing, it doesn't look as good but prints easier.
Print Settings
Printer Brand:
FlashForge
Printer:
Adventurer 3
Yes
Supports:
Yes
Filament:
Sunlu Pla Red and Gold
Category: Sculptures